A ready to apply pigmented patio sealer and patio paint formula suitable for application on most types of concrete paved surfaces. Patio Colour Seal is more effective than a cheap patio paint and can transform the look and appearance of a tired-looking paved area and make it look new. This DIY friendly product is superior to inexpensive concrete paints and is very easy to apply by roller or brush. Prior to application, all surfaces must be cleaned thoroughly and given sufficient time to dry out completely. After two coats have been applied the transformation should be complete.
Patio Colour Seal can be used to refresh the existing colour of old concrete paving or change it completely to a new colour if necessary. Average coverage is approximately 4m² per litre 1st coat (dependent on the surface) and approximately 5m² 2nd coat. If required, an anti-slip additive can be mixed in with the sealer on the final coat if required. There are various colour options for this advanced patio paint and samples available to test if required.
Suitable for most paving slabs including precast concrete
Not for use on imprinted or pressed concrete
Hard wearing.
Ready to apply straight from the tin.
Transforms the look of old concrete paving slabs.
Various colour options available.
DIY friendly.
Makes old paved areas look like new.
Samples available for purchase.
PLEASE NOTE: Patio Colourseal is NOT suitable for use on natural stone surfaces.
*Always apply to a test area first and leave for 5-7 days to determine suitability.
PREPARATION:
Fully clean the surface of the patio slabs using a power washer and patio clean xtreme. Allow to completely dry for a minimum of 72 hours. Apply in temperatures between 12-23 degrees centigrade. Allow 2 hours drying time between coats. Only apply in dry conditions with no rain forecast within 6 hours after application.
APPLICATION:
It is important to thoroughly mix before and during use, ideally with a plasterers paddle. Apply 2 coats by brush or roller (3 coats may be required on older paved surfaces). Add the anti-slip additive if required to improve the slip resistance of the surface. The surface should be fully dry after 24 hours.
COVERAGE:
Average coverage is approx. 4sqm per litre on the 1st coat and 5-6sqm on the 2nd coat.
Fantastic product. The sealer has completely transformed our old patio with very little effort. Would definitely recommend.