Anti-Slip Additive - Mix 1 x 500g to 25L of Sealer (keep stirring regularly)
Use with Solvent Based Sealers (keep stirring reguarly with broom during application). Add to sealer to increase the slip resistance of imprinted concrete surfaces
Anti-Slip Additive for Imprinted Concrete Sealer to make imprinted concrete surfaces less slippery.
Anti-slip additive is added to imprinted concrete sealer to increase the slip resistance of pattern imprinted concrete drives and patios.
Apply direct to sealer drum at a ratio of 1 tub to every 25litre drum, agitate with broom during application. Use of this additive will leave surface of concrete with texture of fine sandpaper, but once dry, the anti-slip additive is invisible to the naked eye.
Use of this product is always strongly recommended to reduce the slippery nature of imprinted concrete driveways and patios.
Only use on final coat of sealer, can be used in greater quantities for extra slippery areas. For further information or application advice please call 01268 722500
Q: Hi. I have topped up my imprinted concrete driveway about 3 years ago and 3 years prior to that also. I have enough sealer left (which has anti slip already mixed in) to probably do one coat however, if I order sufficent sealer to do a second coat will I have to do the first coat WITHOUT Anti slip and then use my pre mixed sealer which has anti slip added already for the top coat?
A: The imprinted concrete sealer with the anti-slip additive mixed in should always be used as the final coat, otherwise it will have no real benefit. There is no reall value of putting the sealer on with anti-slip on both coats.
Q: Can this be added to your porcelain sealer ?
A: No, the porcelain sealer cannot be used in combination with the Anti Slip additive. Using the Porcelain sealer will not adversly effect the slip resistance of the porcelain, so it is not required. The sealer will not increase the slip risk. Hope that helps.
Q: Please could you tell me how many sq metres does this product cover Many thanks
A: 1 x Anti Slip additive should be added to 1 x 25L of Imprinted Concrete Sealer. Depending on age and condition, 25L of sealer will normally cover 100-150m2. Hope that helps.
The anti slip works very well. The drive is better than when it was originally done. Although I was told anti slip was added to sealer originally the drive was very slippery when wet..(I am doubtful it was added). Since resealing and adding this anti slip additive not at all slippery. Very pleased.
Perfect solution for the new layer of sealant I put down
Used the imprinted concrete sealer for first time, very impressed. Added the anti slip and hope this works but will have to wait till winter months.